MI187537- Lot 67 Kubin Road, St Pauls (Bathroom Upgrade)

Overview Torres Strait Island Regional Council is seeking a contractor to carry out bathroom upgrade works at 67 Kubin Rd, St Pauls QLD, 4875. Works shall be quoted for completion during normal hours and shall meet the requirements of the specification. Scope The scope includes: Bathroom upgrade to stud frame construction, including removal and disposal of existing fittings, floor coverings, shower tray, shower combination, tapware, and FC wall and ceiling sheeting Replacement of all damaged or rotten jambs, architraves and mouldings Supply and installation of new 6mm FC sheeting to walls and ceiling Wet sealing of the bathroom in accordance with AS 3740, including the entire floor area, floor wall junctions (minimum 200mm), and the bath tub and shower area (to a minimum height of 1800mm) Provision of a certificate and manufacturer's warranty for the wet seal within 2 weeks of practical completion Supply and installation of a new shower tray as per existing, complete with new stainless steel shower/bath combination, bath spout, shower rose and tapware meeting a minimum 3-Star WELS Water Efficiency rating in accordance with the Queensland Development Code (no copper in wall) Supply and installation of new white Lamipanel to all walls and ceiling, including new treated timber cornice, installed as per manufacturer's recommendations with no mechanical fixings Supply and installation of a new 900mm wide (or as existing, whichever is larger) Cartia waterproof wall/floor mounted vanity cabinet kit, complete with new stainless steel combination, single bowl ceramic top with overflow, and tapware meeting a minimum 3-Star WELS Water Efficiency rating, with high gloss white doors and drawers with soft closing, supported on kicker boards or stainless steel legs, and the carcass securely fixed (a standard vanity unit is to be built and installed to match the opening if the factory Cartia vanity size does not fit) Supply and installation of a new floor waste installed to manufacturer's requirements with correct floor fall to drain the surface Supply and installation of new 200 x 200mm tiles with an R10 slip rating when wet and an X pendulum rating to the floor, ensuring falls to waste, including tiled skirting of one tile high, complying with AS/NZS 4586 Supply and installation of two new towel rails (1200mm x 32mm stainless steel grab rail), soap dish, mirrored shaving cabinet, shower curtain and rail Supply and installation of new obscure film laminate to the bathroom window if the existing glass is clear Upgrade of all plumbing as required, including installation of a tempering valve if required Upgrade of all electrical to the bathroom to meet AS3000, including a new IP54 light fitting and double GPO Repainting of all areas including walls, existing door, window frames, and new and disturbed areas, with full gloss enamel to doors and trims and full gloss acrylic to walls, with all new doors primed and painted in their entirety Replacement of rotten flooring: removal of all existing bathroom flooring and installation of new Scyon Secura Fibre Cement Flooring, replacement of damaged floor joists and addition of extra joists as required, with new bathroom floor falls and waterproofing complying with the NCC and AS3740 Replacement of the existing toilet suite, including pan, cistern and seat to match existing, sealed to flooring with a proprietary sealant, cistern fixed to wall as per manufacturer's details, meeting a minimum 3-Star WELS Water Efficiency rating, and including a new securely fixed toilet roll holder (SS "Emro Toilet Roll Holder Cat. No. 810" or equal approved) Supply and installation of a new 250mm round, ceiling mounted exhaust fan, hardwired and independently switched Contractor Requirements Provide the QBuild Supervisor with a Safe Work Method Statement (SWMS) for any high-risk work prior to starting work onsite Confirm all onsite measurements prior to undertaking works and/or manufacturing, as all measurements provided in the tender are approximate and for quoting purposes only Contract Terms and Conditions On award and prior to commencement of works, the QBuild Supervisor will arrange a prestart meeting with the successful tenderer to discuss site and project specifics. This prestart meeting is mandatory and must be attended by the contractor's representative Information Requested Contractors are required to provide a cost breakup of each element outlined in the Job Summary at the time of tender